The following procedure can be used on a Snap Server (tested with 2200) to reset the settings to factory defaults:
- Power off the Snap Server (wait for all lights to turn off).
- Hold down the reset button while powering the Snap Server on. Wait for the System and Disk lights to flash in unison.
- Release the reset button.
- Press the reset button again according to the action you wish to perform:
- Once to reset the IP address.
- Twice to reset the Admin password (default is blank).
- Three times to clear the network settings
- Four times to clear all settings
- Five times to initiate FLUP mode (for updates)
- Six times to boot without mounting hard drives.
- Watch the disk light to confirm that it blinks the correct number of times to correspond with your selection. If it doesnt, repeat step 4.
- Press and hold the reset button until the Snap Server resets.